comments

flower_pot/weave_planter.scad

@@ -3,11 +3,8 @@
 //  Parametric.
 //  Reverse-engineered from "Planter - 100mm" and "Drip Tray - 100mm" STLs (https://www.printables.com/model/1507840-weave-planter).
 //
-//  Outside:  diagonal basket weave (two strip directions crossing over/under,
-//            45 deg chamfered strip edges, dark diamond gaps between strips).
-//  Lock:     4 lugs on the tray rim pass between 4 stops on the underside of
-//            the planter. Push the planter down onto the tray with the lugs in
-//            the gaps, then twist ~45 deg so every lug sits over a stop.
+//  Outside:  diagonal basket weave (two strip directions crossing over/under, 45 deg chamfered strip edges, dark diamond gaps between strips).
+//  Lock: 4 lugs on the tray rim pass between 4 stops on the underside of the planter. Push the planter down onto the tray with the lugs in the gaps, then twist ~45 deg so every lug sits over a stop.
 //
 //  Both parts print as modelled (flat side down, no supports):
 //    - weave strips have 45 deg chamfers, ends of the weave taper 45 deg
@@ -148,8 +145,7 @@ function g_faces(a, dl, P, off) =
         g_q(a, dl + 1, P)     ? [] : [[p01, p11, i11], [p01, i11, i01]],
         g_q(a - 1, dl + 1, P) ? [] : [[p00, p01, i01], [p00, i01, i00]]);
 
-// Ring-shaped skin whose outer surface is the weave between z0 and z1, with the
-// 45 deg run-out at both ends (trimmed by the envelope below).
+// Ring-shaped skin whose outer surface is the weave between z0 and z1, with the 45 deg run-out at both ends (trimmed by the envelope below).
 module weave_skin(z0, z1) {
     L    = z1 - z0;
     M    = nl * N;